Turn the rear panel volume control fully counterclockwise.
If using as a floor monitor, set the MONITOR/FOH switch to the MONITOR position.
Turn the power switch OFF.
Connect the monitor output of your mixer to the input jack on the rear panel of the RSXM10a/RSXM12a.
If you are connecting an additional speaker, connect the XLR line output of the first speaker to the input of the second RSXM speaker.
Connect the supplied power cord to the AC power input on the back of the speaker. Plug the power cord into an AC power outlet. Note: Always make sure the AC outlet is configured for the correct voltage, as indicated on the back of the RSXM speaker.
Turn the RSXM power switch to the ON position.
Apply an audio signal from your mixer.
Slowly increase the RSXM VOL control until the desired level is reached.
If the sound from the speakers is distorted, or the LIMITER light blinks frequently, turn down the input level control on the RSXM speaker until the light goes out.
Comments
0 comments
Article is closed for comments.